ORIGINAL ROCKFORD FOSGATE PRIME USA R150X2 150W RMS 2 CHANNEL AMPLIFIER

ORIGINAL ROCKFORD FOSGATE PRIME USA R150X2 150W RMS 2 CHANNEL AMPLIFIER

The PRIME R150X2 is a 2-channel amplifier that can pump-out 75 Watts into both channels at 2-Ohms, making it perfect for full-range or component speakers. The R150X2 can also run in bridged/mono mode for use with subwoofers.

Rockford Fosgate amplification at an unbelievable value. The R150X2 2-channel amplifier pumps out more than enough to power a set full-range or component speakers, or you can bridge it into a 4-ohm load to produce 150 watts for a single R1S410 10" or R1S412 12" woofer. Check out our RFTECH:Woofer WiringWizard to get the most out of your amplifier.

Technologies:

• CEA-2006 Compliant - Power ratings on Rockford Fosgate amplifiers conform to CEA-2006 industry standards. These guidelines mean your amplifier's output power ratings are REAL POWER numbers, not inflated marketing ratings.
• CE Compliant - This product fulfills all essential safety and environmental requirements as defined in the European Directives (768/2008 EC).
• Class A/B - An amplifier topology with the best of both worlds; a Class A preamp and Class B output stage.

Specifications:

• CEA-2006 Compliant: CEA-2006 Power Rating 50W x 2 @ 4Ω ≤1.0% THD+N
• Number of Channels: 2
• Total Power (Sum of Rated Power): 150 Watts RMS
• Rated Power (RMS Continuous Power): 50 Watts x 2 @ 4-Ohm ; 75 Watts x 2 @ 2-Ohm ; 150 Watts x 1 @ 4-Ohm Bridged
• Dynamic Power (PVC/PowerCube®): 61 Watts x 2 @ 4-Ohms 0° Res ; 94 Watts x 2 @ 2-Ohms 0° Res
• Bridgeable: Yes
• Frequency Response: 20Hz to 20kHz +/-1dB
• Input Sensitivity: 150 mV to 4 V
• Circuit Topology Class: Class A/B
• Efficiency (average): 66% @ 4-Ohm
• Total Harmonic Distortion (THD+Noise): 4-Ohm: <1.0% ; 2-Ohm: <1.0%
• Signal Input: High Level: 4-pin molex ; Low Level: 1 RCA pair
• Signal Output: Low Level: 1 RCA pair
• Tone Controls: Punch Bass: 0dB to +12dB @ 45Hz
• Crossover Controls: High-Pass/Low-Pass (HP/LP): 50-250Hz @ 12dB/octave Butterworth
• Remote Controls : -
• Visual Indicators: Power/Protect LED
• Power Wire Gauge: 4 AWG
• Power Input Connector: Screw terminal
• Speaker Wire Gauge: 8 AWG
• Speaker Output Connector: Screw terminal
• Cooling: Convection
• Heatsink: -
• Operating Voltage: 9 - 16 VDC
• Recommended Fuse (not included): 20 A
• Average Current Draw (13.8V Music): 10 A
• Max. Current Draw (13.8V Sinewave): 20 A
• Suggested Alternator: 75 A
• Dimensional Diagram: -
• Dimensions (H x W x D)1.98 x 6.77 x 11.22 (in) ; 5 x 17.2 x 28.5 (cm)
• Shipping Weight6.6 Lbs. (2.99 Kg.)

Overview:

• 12dB/octave Butterworth crossover
• On-board Punch EQ with +18dB boost @ 45Hz
• RCA pass-thru outputs
• High Level Input (4-pin)
• Real time output and power supply thermal sensing
• Cast aluminum heatsink
• 4 Gauge power/ground connectors
• MOSFET power supply
• Over current protection
• Short circuit protection
• Muted turn on
• 1 Year Local Warranty By AutoCraft Electronics (M) Sdn Bhd